To reduce the gate leakage current of AlGaN/GaN HEMTs, we selected ITO/Ni/Au for Schottky electrodes and Schottky characteristics were compared with those of Ni/Au electrodes. ITO/Ni/Au and Ni/Au electrodes were deposited by vacuum evaporation and annealed at 350°C in nitrogen atmosphere. From the I-V evaluation results of ITO/Ni/Au electrodes, forward and reverse leakage currents were reduced. Schottky characteristics of ITO/Ni/Au electrodes were also improved compared to these of Ni/Au electrodes. In addition, substantial decrease of leakage currents was confirmed after the annealing of HEMTs with ITO/Ni/Au electrodes. This may be explained that ITO/AlGaN interface state became lower by the annealing. By the temperature dependence of I-V curves, clear dependence was confirmed for the gates with ITO/Ni/Au electrodes. On the other hand, small dependence was observed for those with Ni/Au electrodes. From these results, tunnel leakage currents were dominant for the gates with Ni/Au electrode. Thermal emission current was dominant for the gates with ITO/Ni/Au electrode. The larger temperature dependence was caused that ITO/AlGaN interface states were smaller than those for Ni/Au electrode. It was suggested that suppressed AlGaN Schottky barrier thinning was caused by the surface defect donors, then tunneling leakage currents were decreased. We evaluated HEMT characteristics with ITO/Ni/Au electrode and Ni/Au electrode. I_{d max} and G_{m max} were similar characteristics, but V_th, with ITO/Ni/Au electrode was shifted +0.4V than that with Ni/Au electrode due to the higher Schottky barrier. It was confirmed to have a good pinch-off currents and low gate leakage currents by ITO/Ni/Au electrodes.