An outlier detection, usually called measurement editing, is commonly used by data fusion algorithms. In a typical implementation, a measurement is accompanied by an estimate for its standard deviation. If the measurement residual exceeds some multiple of standard deviations (e.g., 4), the editing algorithm rejects this measurement as an outlier. The standard approach does not provide any guidance for setting the threshold. A threshold that is too low rejects legitimate measurements, and the filter may get "stuck" in a wrong state. A threshold that is too high lets outliers in, affecting the quality of a solution. A modern navigation system integrates data from different sensors that have different error statistics, including the amount and the severity of outliers. A sensor-specific approach for treating outliers becomes a necessity. For a Gaussian statistics, large residuals are exponentially rare, and outliers are not an issue. Unfortunately, the nature rarely follows Mr. Gauss; any hopes to salvage the situation by invoking the Central Limit Theorem are crushed by a Gaussian's extremely slow convergence at the tails. In practice, "fat tails" are quite common and are at the root cause of solution errors due to outliers. In this paper, we present two new method of detecting and treating outliers. These methods are consistent with the general philosophy of optimal fusion: process only the data that is needed, with weights that accurately reflect data error statistics. The first method uses Pickands - Balkema - de Haan (PBdH) theorem to detect fat tails. For any particular sensor, we pre-process large amount of data and estimate the statistics of the tail of the error distribution. We derived a formulation that translates the tail statistics into actionable outlier rejection algorithm and/or into a means for pre-processing measurements before they are fed into a navigation filter. In a simple case, the algorithm is similar to the conventional threshold for measureme...