Abstract
The productivity of machine tools is often limited due to chatter vibrations caused by relative displacements between the tool and the workpiece. The following article presents the systematic approach of the integration of an active workpiece holder with two high dynamic axes controlled by piezoelectric actuators onto a milling machine. With these additional highly dynamic axes near the tool center point, the active workpiece holder offers possibilities to prevent chatter vibrations.
Similar content being viewed by others
References
Neugebauer R, Denkena B, Wegener K (2007) Mechatronic systems for machine tools. Ann CIRP 56
Keiser R (2007) Kompensation von statischen und dynamischen Verlagerungen im Fräsprozess. Dissertation, RWTH-Aachen
Roth M (2009) Einsatz und Baurteilung eines aktiven Strukturdämpfers in einem Bearbeitungszentrum. Dissertation, TU Darmstadt
Michels F (1998) Stabilisierung des Schleifprozesses mit aktiven Systemen. Dissertation, RWTH-Aachen
Brecher C, Schauerte G, Merz M (2008) Model based control of a piezo-actuated axis. The 41st CIRP conference on manufacturing systems
Abele E, Hanselka H, Haase F, Schlote D, Schiffler A (2008) Development and design of an active work piece holder driven by piezo actuators. Prod Eng Res Dev 2
Munzinger C (2006) Adaptronische Strebe zur Steifigkeitssteigerung von Werkzeugmaschinen. Dissertation, Universität Karlsruhe
Brecher C, Manoharan D, Ladra U, Köpken H-G (2009) Aktive Werkstückauflage zur Rattervermeidung, wt Werkstattstechnik (online H. 1/2/2009)
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Brecher, C., Manoharan, D., Ladra, U. et al. Chatter suppression with an active workpiece holder. Prod. Eng. Res. Devel. 4, 239–245 (2010). https://doi.org/10.1007/s11740-009-0204-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11740-009-0204-y