Abstract
In this study, a CFD (computational fluid dynamics) technique is used to investigate the roles of urban geometry, wind direction, and wind velocity in an urban environment. By applying efficiency concepts originally developed for indoor environments, the term “ventilation” is used as a measure of city “breathability.” Two types of building geometries are considered—cases featuring simple building blocks and actual urban blocks—which represent the configuration irregularity of Niigata City. The results obtained in the simple building block cases indicate that the wind velocity is low, and the air temperature and scale of the ventilation efficiency (age of the air) are generally high in an area crowded with low-rise buildings. On the other hand, in the areas around high-rise buildings, the air temperature and age of the air are relatively low as a result of strong winds from higher altitudes. These tendencies can also be observed in the actual urban block case. These results demonstrate that the scale of the ventilation efficiency such as the age of the air is useful in quantifying a city’s breathability.
Graphical Abstract
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Bady M, Kato S, Huang H (2008) Towards the application of indoor ventilation efficiency indices to evaluate the air quality of urban areas. Build Environ 43:1991–2004
Berkowicz R, Winther M, Ketzel M (2006) Traffic pollution modelling and emission data. Environ Model Softw 21:454–460
Blocken B, Carmeliet J (2004) Pedestrian wind environment around buildings: literature review and practical examples. J Therm Envel Build Sci 28:107–159
Buccolieri R, Sandberg M, Di Sabatino S (2010) City breathability and its link to pollutant concentration distribution within urban-like geometries. Atmos Environ 44:1894–1903
Di Sabatino S, Buccolieri R, Pulvirenti B, Britter R (2007) Simulations of pollutant dispersion within idealised urban-type geometries with CFD and integral models. Atmos Environ 41:8316–8329
Durbin PA (1996) On the k-ε stagnation point anomaly. Int J Heat Fluid Flow 17:89–90
Franke J, Hellsten A, Schlünzen H, Carissimo B (2007) Best practice guideline for the CFD simulation of flows in the urban environment. COST Action 732
Hang J, Sandberg M, Li Y (2009a) Effect of urban morphology on wind condition in idealized city models. Atmos Environ 43:869–878
Hang J, Sandberg M, Li Y (2009b) Age of air and air exchange efficiency in idealized city models. Build Environ 44:1714–1723
Hang J, Li Y, Sandberg M (2011) Experimental and numerical studies of flows through and within high-rise building arrays and their link to ventilation strategy. J Wind Engng Ind Aerodyn 99:1036–1055
Huang H, Kato S, Ooka R, Jiang T (2006) CFD analysis of ventilation efficiency around an elevated highway using visitation frequency and purging flow rate. Wind Struct Int J 9:297–313
Kato S, Huang H (2009) Ventilation efficiency of void space surrounded by buildings with wind blowing over built-up urban area. J Wind Engng Ind Aerodyn 97:358–367
Kato S, Murakami S (1988) New ventilation efficiency scales based on spatial distribution of contaminant concentration aided by numerical simulation. ASHRAE Trans 94:309–330
Mochida A, Iizuka S, Tominaga Y, Lun IYF (2011) Up-scaling CWE models to include mesoscale meteorological influences. J Wind Engng Ind Aerodyn 99:187–198
Neophytou M, Britter R (2005) Modelling the wind flow in complex urban topographies: a computational-fluid-dynamics simulation of the central London area. In: Proceedings of the 5th GRACM Inter Congress on Comput Mech, 29 June–1 July, Limassol
Tominaga Y, Mochida A, Murakami S, Sawaki S (2008a) Comparison of various revised k-ε models and LES applied to flow around a high-rise building model with 1:1:2 shape placed within the surface boundary layer. J Wind Engng Ind Aerodyn 96:389–411
Tominaga Y, Mochida A, Yoshie R, Kataoka H, Nozu T, Yoshikawa M, Shirasawa T (2008b) AIJ guidelines for practical applications of CFD to pedestrian wind environment around buildings. J Wind Engng Ind Aerodyn 96:1749–1761
Tominaga Y, Stathopoulos T (2009) Numerical simulation of dispersion around an isolated cubic building: comparison of various types of k-ε models. Atmos Environ 43:3200–3210
Yoshida S, Ooka R, Mochida A, Murakami S, Tominaga Y (2006) Development of three dimensional plant canopy model for numerical simulation of outdoor thermal environment. In: 6th Inter Conf on Urban Climate (ICUC6), June 12–16, Göteborg, Sweden
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Tominaga, Y. Visualization of city breathability based on CFD technique: case study for urban blocks in Niigata City. J Vis 15, 269–276 (2012). https://doi.org/10.1007/s12650-012-0128-z
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12650-012-0128-z