Abstract
Geiger iterative algorithm is very strict to the initial value. If the initial value is not selected suitably, it is difficult to enter the convergence range, thus increasing the number of iterations. The acoustic emission source location based on phase difference time delay estimation method reduces the error of acoustic emission location, but it has some shortcomings in accuracy. Based on the above problems, this paper presents a new algorithm for Geiger optimization based on source localization. Firstly, the initial value of Geiger is obtained by using the phase difference method. Then, the optimal solution is obtained by the iterative solution of Geiger algorithm and the least square method. The simulation results show that this method can effectively solve the problem of selecting the initial value of Geiger, so that it can quickly enter the convergence range, improving the convergence speed and positioning accuracy, comparing the positioning results of the United States PCI-2 type acoustic emission instrument, the average error reduced by about 5 mm.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Mogi, K., Study on elastic shocks caused by the fracture of heterogeneous material and its relation to earthquake phenomena, Bull. Earthquake Res. Inst., 1962, vol. 40, no. 6, pp. 831–853.
Scholz, C., Experimental study of the fracturing process in brittle rock, J. Geophys. Res., 1968, vol. 73, no. 5, pp. 1447–1454.
Jansen, D.P., Carlson, S.R., Young, R.P., et al., Ultrasonic imaging and acoustic emission monitoring of thermally induced micro cracks in Lac du Bonnet granite, J. Geophys. Res., 1993, vol. 98, no. B12, pp. 22231–22243.
Zhao, X.D., Liu, J.P., Li, Y.L., et al., Experimental verification of rock locating technique with acoustic emission, Chin. J. Geotech. Eng., 2008, vol. 30, no. 10.
Huang, X.H., Zhang, Y.B., Tian, B.Z., et al., Time delay estimation and acoustic emission source location of rock based on phase difference, Chin. J. Geotech. Eng., 2015, vol. 36, no. 2, pp. 382–383.
Kang, Y.M., Liu, J.P., Hai-bin, L.I., et al., An AE source location combination algorithm based on least square method, J. Northeast. Univ., 2010, vol. 31, no. 11, pp. 1648–1651.
Lu, X.N., Research on frequency detection algorithm of railway signal based on full phase FFT, Master Degree Thesis, Hainan: University of Hainan, 2013.
Pang, Q.L., Sun, S.L., and Wei, L.N., The fault signal detection based on ApFFT, Manuf. Autom., 2010, vol. 32, no. 7, pp. 96–99.
Ma, X.M., Acoustic emission signal location of rock, Master Degree Thesis, Hebei: Hebei United University, 2014.
Liu, J.P., Wang, H.Y., Yang, Y.J., et al., Experimental study on different rock locating algorithms with acoustic emission, J. Northeast. Univ., 2009, vol. 30, no. 8, pp. 1194–1195.
Huang, X.H. and Deng, Z.M., An improved phase unwrapping algorithm and its application to instantaneous frequency estimation, Acta Electron. Sin., 2009, vol. 5, no. 10, pp. 224–230.
Kang, Y.M., Study on acoustic emission source location method of rock materials based on wavelet analysis, Doctoral Dissertation, Jilin: Northeastern University, 2009.
Pei, J.L., Liu, J.F., Zhang, R., et al., Fractal study on spatial distribution of acoustic emission events of granite specimens under uniaxial compression, J. Sichuan Univ. Eng. Sci. Ed., 2010, vol. 42, no. 6, pp. 51–55.
Author information
Authors and Affiliations
Corresponding author
Additional information
The article is published in the original.
About this article
Cite this article
Huang, X., Sun, G. & Zhang, K. Research on the location of acoustic emission source of rock breaking point by using phase difference method and Geiger algorithm. Aut. Control Comp. Sci. 50, 378–384 (2016). https://doi.org/10.3103/S0146411616050059
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0146411616050059